FEATURES:
Works with all major receiver brands including Spektrum, Futaba, Hitec, JR, Tactic, and more.
Integrated design of 6-axis (3 gyro+3 accelerometers ) 32-bit MEMS sensor for self-stability and self-balance.
Advanced brown-out fast recovery ability provides better security and reliability.
6 Flight modes:
Normal Mode (2D Mode): this is the standard flight stabilization mode found on most airplane gyros.
3D Flight Mode: this mode will attempt to hold the LAST position the aicraft was in.
Auto-Recovery Mode (also called Auto Balance Mode): this mode will automatically "right" or balance your aircraft
Auto-Hover Mode: this mode will hold the airplane in a perfect hover (nose pointed towards the sky) on 3D capable aircraft.
User Defind: allows you to select different modes (Normal, 3D, or Off) for each gyro axis.
Gyro Deactivated Mode: this turns the gyro off to allow unassisted/non-stablized flight.
2 stick control modes: Manual Mode(MM) and Auto Mode(RR/AR).
Various wing types: 1AIL+1ELE, 2AIL+1ELE, 1AIL+2ELE, 2AIL+2ELE, delta-wing and V-tail.
Independent gyro gain adjustment and gyro ratio selection for each flight mode.
Separate adjustments for servo travel limits.
Up to 333Hz servo operating frequency, compatible with all analog and digital servos.
5-level response rate setting allows you to use it on gas-powered planes.
Compatible with HV (7.4V) receivers and servos.
Flat or upright mounting orientations.
Newly designed config GUI makes gyro setup simple and intuitive.
Easy-to-use programming module for gyro setup without a PC.
SPECIFICATIONS:
Main Controller: 32-bit MCU
Sensor: 3-axis gyroscope and 3-axis accelerometer
Gyroscope Scale Range: 2000 dps
Accelerometer Scale Range: 4g
Input Signal: Standard PPM with center point 1520uS, or S.Bus serial data
Output Signal: PWM max frequency 333Hz, 1520500uS
Input Voltage: 4.8V - 7.4V
Operating Temp: -10 ℃ to 50 ℃
Size: 432714mm
Weight: 10g (excluding wires)
INCLUDES:
Eagle A3 Super II Flight Stabilizer
Programming module with LCD display
NEW - 16V EZ-Plug capacitor to help maintain a secure voltage level during flight
Data cable
USB Adapter (to connect stabilizer to PC or programming module to PC)
One 15cm male to male receiver cable
Two 15cm male to male 3-way receiver cables
Tech Note: This is the only gyro we recommend for Gas and Nitro plane use as it has a dampening feature called "Response Rate" for vibration.
Your page text goes here